How to Dry Wood PLA Filament Before Printing?

Find the drying temperature and time for your wood PLA spool, then compare two matching test prints to see whether drying helped.

By XUCHUN

How to Dry Wood PLA Filament Before Printing?

XUCHUN

For INKCLOUD PLA Wood, the published drying recommendation is 50 ± 5 °C for 4–8 hours in a filament dryer. If you use another wood-filled PLA, check the guidance for that exact spool. Some manufacturers advise drying before the first print, while others give a drying cycle for spools that have picked up moisture. INKCLOUD PLA Wood drying specifications

Choose the drying cycle for your spool

Filament Manufacturer guidance
INKCLOUD PLA Wood 50 ± 5 °C for 4–8 hours in a filament dryer. INKCLOUD PLA Wood
Bambu Lab PLA Wood Bambu advises drying before use and lists 55 °C for 8 hours in a forced-air drying oven. Bambu Lab PLA Wood
Prusament Woodfill Prusa says routine drying before printing is optional for this material. Its drying guide lists 45 °C for 6 hours when drying is needed. Prusament Woodfill guide · Prusa drying table

Check that the spool itself can tolerate the drying temperature, especially if you’ve rewound the filament onto a different reel. Use a dryer that can hold the specified temperature. Temperature swings in a household oven can soften PLA or cause adjacent windings to stick together. Prusa guide to drying equipment and spool limits

Check whether drying helped

If a spool that used to print cleanly starts bubbling during extrusion or leaves new pits and rough patches, moisture is one possible cause. Save the affected print or take a close-up of its surface. After drying, reprint the same small part using the same nozzle temperature, speed, and retraction. Compare the same area on both samples. Fewer bubbles or pits suggest drying helped. Prusa guide to recognising moisture in filament

If the walls are smooth and the only remaining issue is fine threads between features, check nozzle temperature and retraction before running another drying cycle. Change one setting at a time so you can see what improves the result. Prusa stringing and oozing guide

Store the spool between prints

After the spool cools, place it in a sealed bag or container with dry desiccant. Use the heated dryer for the drying cycle and the sealed container to limit moisture exposure between jobs. For INKCLOUD PLA Wood, the product page lists a storage recommendation below 20% relative humidity. INKCLOUD PLA Wood storage guidance

Zurück Weiter
Kommentar hinterlassen 0 Kommentare

    Weitere Artikel lesen