Translucent PETG Filament Settings for Even Color and Smooth Walls
XUCHUNA translucent PETG cover can look good from one angle and reveal a seam, streak, or dull band when light passes through it. For decorative housings and coloured covers, tune the print around the surfaces people will actually see.
The following translucent PETG filament settings provide a starting point for INKCLOUD PETG Translucent. Use a short section of your final model to check them before printing the complete part.
Start With a Controlled Test
| Setting | Suggested first trial | INKCLOUD published guidance |
|---|---|---|
| Nozzle temperature | 245 °C | 230–260 °C |
| Bed temperature | 70 °C on a compatible plate | 60–80 °C |
| Part cooling | 30% after the initial layers | 0–60% |
| Outer-wall speed | 50 mm/s | General print speed of 50–200 mm/s |
Use the installed nozzle’s matching slicer profile. A 0.4 mm nozzle with 0.20 mm layers is a practical trial setup. Keep wall thickness and orientation consistent while comparing settings. INKCLOUD PETG Translucent specifications
Prepare the plate according to its manufacturer’s PETG instructions. Some smooth PEI surfaces require a separation layer because PETG can adhere strongly. Prusa print-surface preparation guide
Clear the Previous Colour Before Printing
After changing from another filament, follow the printer’s loading and purging procedure. Inspect the extruded strand until its colour appears consistent.
A short sample printed before the main job gives you a chance to spot remaining colour contamination. Purging removes traces of the previous colour from the hotend. Prusa explanation of filament purging
Put the Seam Where the Design Can Accommodate It
Preview the seam before printing. On a rectangular housing, try placing it along a rear corner. On a round cover, choose the side that will face away from the viewer.
Print the test section with the intended seam position and inspect it both under room light and against a broad light source. If the seam forms a noticeable ridge, check extrusion consistency and the printer’s retraction or pressure-control calibration. Positioning the seam helps manage its visibility. Prusa seam-position guide
Check Speed Changes When Gloss Becomes Uneven
If the print has shiny and dull bands, compare those heights with the slicer’s speed preview. Overhangs and short layers may print more slowly than straight walls.
Test a lower outer-wall speed while keeping temperature fixed. Inspect the sliced preview again to see whether the speed difference has narrowed. Keep cooling appropriate for the model’s overhangs and bridges. Differences in speed, melting behaviour, and cooling can affect surface gloss. Bambu Lab guide to gloss differences
Respond to the Defect You Can See
| Appearance | Next check |
|---|---|
| Discoloured streaks near the beginning | Repeat the loading check and inspect for residual material. |
| A continuous raised line | Inspect seam placement and extrusion at layer starts. |
| Regular shiny and dull bands | Compare speed changes at the same heights. |
| Random pits, bubbles, or popping | Check for moisture, dry according to the spool’s instructions, and repeat the same sample. |
INKCLOUD specifies 60 ± 5 °C for 4–8 hours in a filament dryer for PETG Translucent. Once the sample has the colour and surface consistency you want, save the profile with the spool name and nozzle size. View INKCLOUD drying guidance and translucent colours