How to Hide Seams in Brick Models with High-Detail Rigid Resin?

Print a modular brick façade in high-detail rigid resin. Learn where to split the wall, how to align the panels, and how to spot gaps or bowing before assembly.

By XUCHUN

How to Hide Seams in Brick Models with High-Detail Rigid Resin?

XUCHUN

A brick façade can print with crisp mortar lines and still look like two separate pieces when assembled. The giveaway is often a straight split through the middle of the brickwork or a raised edge that catches the light. When printing a modular wall with high-detail rigid resin, plan the joint while the façade is still a single CAD model.

Draw the split along the mortar lines

Model the full wall with all the brick courses aligned. Choose a split between two windows and trace it through the recessed mortar joints. Follow a short horizontal joint where you need to move sideways, then continue down the next vertical joint. This creates a staggered edge that blends into the brick pattern once the panels meet.

Keep each window arch on one panel. If a continuous sill or cornice crosses the joint, consider printing it separately so it can span both panels during assembly. Leave enough material behind the brick relief to keep the staggered edge from becoming a row of thin, fragile tabs.

Try the joint on a short section first

Export a small section from each side of the seam. Include several brick courses and the full panel thickness. Print both sections at the intended scale using the same resin, profile, orientation, and post-processing you plan to use for the wall.

For a supported print, try tilting the panels and placing support contacts on the rear where practical. Check the slicer preview around the staggered edges and window arches for areas that begin without support. Keep the surfaces that will sit against the backing board clear of support remnants. Formlabs guide to resin print orientation

Dry-fit the cured panels on a flat backing

Set the two cured pieces against a flat backing board and align their bottom edges. Check the joint from the front, then shine a light across the brickwork from the side.

What you see What to check
The brick courses align, but the seam looks wider than the other mortar lines. Check whether a bump or support remnant is holding the edges apart. If the sample seats fully, adjust the modeled joint clearance.
The gap is narrow, but one face casts a shadow onto the other. Check whether the backs sit flat and the panels have the same thickness.
The joint closes at one end and opens at the other. Put a straightedge against each mating edge to check for bowing. Review print support and post-processing before changing the joint geometry.

The short samples confirm how the joint fits. Repeat the dry fit on the first pair of full-size panels before printing the rest, since larger panels can still bow during printing, washing, or curing. Once the brick courses align and the faces sit flush, use the flat backing to hold that alignment during final assembly. Formlabs guide to resin print warping

Anterior Siguiente
Deja un comentario 0 comentarios

    Leer más artículos