How to Print Matching Bookends with PETG Rainbow Filament?
XUCHUNPrint one bookend in the morning and its mirror in the afternoon, and you might end up with a purple base on one and a peach base on the other. With PETG rainbow filament, the colors change along the strand as the printer uses it. Two separate jobs can start at different points in that sequence. To get a closer match, put both parts on the same build plate and print them together, one layer at a time.
Give both bookends the same print geometry
Start with one model and mirror it left to right in the slicer. Keep both bases flat on the plate and both uprights at the same height. Use the same layer height, wall count, and infill so the two shapes need roughly the same amount of material at each level. If the design has a foot that slides under the books, check that both feet point inward when you picture the pair on the shelf.
Keep decorations and support requirements similar across the pair. Extra geometry consumes additional filament, which can affect where later transitions appear.
Check that the printer alternates between the two parts
Select Print by Layer, or leave Complete Individual Objects turned off in PrusaSlicer. In the sliced preview, follow a layer above the base. You should see extrusion on both bookends before the printer moves up to the next layer. This keeps the two parts drawing from nearby sections of the spool and usually produces a closer color match than finishing one bookend first. A transition can still begin during the paths for one part, so expect some variation at the same height. Prusa guide to print order
For INKCLOUD PETG Basic Rainbow, the published settings are 230–260°C for the nozzle and 60–80°C for the build plate. Use a PETG profile that suits your printer, nozzle, and plate. INKCLOUD PETG Basic Rainbow print settings
Read the result before changing settings
-
The colors shift at slightly different heights. Compare both bookends side by side under the same light. Small offsets can still look coordinated when the sequence of colors is similar.
-
Both parts show only one or two hues. That job may have used only part of the spool’s color sequence. Try the next pair from a different starting section if you want a different palette.
-
You need to replace one bookend later. Keep a photo of the original pair as a color reference. If a close match matters, printing a fresh pair together is easier than trying to recreate the original starting position on the spool.
Once the parts cool, set them on the shelf and check that both bases sit flat and stay in place with the books you intend to use.