1.75 mm Glow-in-the-Dark PLA Filament: What to Check Before You Buy?
XUCHUNChoose 1.75 mm glow-in-the-dark PLA filament if your printer specifies 1.75 mm filament. The number refers to the diameter of the strand on the spool. A 0.4 mm nozzle refers to the opening where the melted plastic comes out. Check both specifications before you order, especially if the product page offers several diameters.
Two printers can use the same nozzle size and different filament sizes
The Original Prusa MK4S uses 1.75 mm filament and ships with a 0.4 mm nozzle. The UltiMaker S5 also ships with 0.4 mm print cores, but its specified filament diameter is 2.85 mm. Look for Filament diameter or Compatible filament diameter in your printer’s specifications to find the size to buy. Prusa MK4S specifications · UltiMaker S5 specifications
Three checks before you add a spool to your cart
| Check | What to confirm |
|---|---|
| Filament diameter | Match the selected product variant to the diameter your printer takes. Double-check the selected size in the cart. |
| Nozzle size and material | Check the filament maker’s recommended nozzle sizes. Some glow pigments can wear brass, so consider a compatible hardened nozzle if you print with glow filament regularly. |
| Spool fit | If the spool goes inside a feeder or dry box, check its outer diameter and width against the device’s limits. If it mounts on a hub, check the center-hole diameter too. For an automatic feeder, also confirm that it supports the filament itself. |
INKCLOUD lists 0.4, 0.6, and 0.8 mm nozzle sizes for its PLA Glow. Check that your printer supports the nozzle you choose, then select the installed size in your slicer. INKCLOUD PLA Glow specifications · Prusa guide to abrasive materials and nozzles
How to check an unlabeled spool
If the label is missing, use calipers on a straight section of filament. Close the jaws gently across the strand and repeat at a few points. A rough measurement can help distinguish a 1.75 mm spool from a 2.85 mm spool. To assess diameter consistency, compare several readings with the manufacturer’s published tolerance for that filament.
If your printer takes 1.75 mm filament, select 1.75 mm under Size, then choose the glow color and spool weight for your project. Explore INKCLOUD PLA Glow