How to Print Wood PLA on Bambu Lab Printers?

Set up wood PLA in Bambu Studio, check whether your spool can run through AMS, and test a custom preset before a full print.

By XUCHUN

How to Print Wood PLA on Bambu Lab Printers?

XUCHUN

When you print wood PLA on a Bambu Lab printer, start by checking the brand on the spool. Bambu PLA Wood has its own preset and documented AMS compatibility. For a third-party wood-filled PLA, use the settings supplied with that spool and check whether the manufacturer supports your feeder.

Choose the feed path and preset for your spool

Filament Feed path Bambu Studio preset
Bambu Lab PLA Wood Bambu lists its own PLA Wood as compatible with AMS and AMS lite. Select Bambu PLA Wood if available for your printer and installed nozzle.
INKCLOUD PLA Wood If AMS compatibility is unconfirmed for your setup, use the printer’s external spool holder for the first single-colour print. Start with Generic PLA and save a custom preset using the INKCLOUD settings.

Choose the 1.75 mm filament option for a Bambu printer that takes 1.75 mm filament. Bambu excludes the 0.2 mm nozzle for its own PLA Wood, and INKCLOUD lists 0.4, 0.6, and 0.8 mm nozzle options. Match the nozzle selected in Bambu Studio to the one actually installed. Bambu Lab PLA Wood specifications · INKCLOUD PLA Wood specifications

Save a preset for third-party wood PLA

In Bambu Studio, select your printer, nozzle diameter, and build plate. Open the filament settings for Generic PLA and save a copy under a name you’ll recognise, such as INKCLOUD PLA Wood – 0.4 mm. For INKCLOUD PLA Wood, the published nozzle range is 190–240 °C and the bed range is 55–65 °C for its listed plate types. Enter the temperatures for your chosen setup, then select the correct filament source when sending the print. Bambu Studio Generic PLA profile · INKCLOUD print settings

Test a feature from the final model

For a pavilion with narrow slats, print a short section with a few slats and a corner before committing to the full model. Keep the same layer height and orientation as the final print. If the filament loads smoothly but you see bulges or gaps around corners, check Flow Dynamics calibration for your printer. If flat surfaces show consistent over- or under-extrusion, check the feed path and nozzle, then use Flow Rate calibration if the issue persists. Save the result with the custom filament preset so you can reuse it with that spool and nozzle. Bambu Lab X2D manual, filament calibration

Précédent Suivant
Laisser un commentaire 0 commentaire

    Lire plus d'articles