A wet filament print may show bubbles, stringing, rough walls, voids and inconsistent extrusion—but similar defects can have other causes. Learn how to inspect...
Popping, bubbles and unstable extrusion can indicate wet filament, while stringing and rough surfaces have several possible causes. Learn which symptoms provide stronger evidence...
First-layer ripples are not all caused by the same problem. Learn how ripple location, direction and timing can identify incorrect nozzle height, excess flow,...
Gaps in a 3D print first layer can come from excessive nozzle height, under-extrusion, uneven leveling, incorrect line width, or slicer path generation. Use...
First-layer failures do not all have the same cause. Use this symptom-based guide to diagnose adhesion loss, gaps, ridges, uneven leveling, corner lift, elephant...
Is your first layer attached but covered in ridges, waves, gaps, or nozzle scars? Learn how to identify incorrect nozzle height, uneven leveling, excessive...
Are the upper edges of your 3D print curling, sagging, or lifting? Learn how to distinguish true top-layer warping from pillowing, overheating, weak infill...
Is the bottom of your 3D print curved, raised, or uneven? Learn how to distinguish true warping from elephant foot, incorrect first-layer squish, support...