How to Fit Locating Pins in ABS-Like 3D Printer Resin Parts?

Use a test coupon to check hole size and pin spacing on an ABS-like resin enclosure. Learn when to use printed holes and how to finish them after curing.

By XUCHUN

How to Fit Locating Pins in ABS-Like 3D Printer Resin Parts?

XUCHUN

Two locating pins can make a prototype enclosure easy to line up. They can also make the lid bind halfway down. Before reaching for a larger drill bit, check whether each pin fits by itself. If both fit individually, the problem may be the distance between the holes or the angle at which the pins enter.

ABS-like 3D printer resin is a UV-curable photopolymer used for prototypes that need to withstand handling and assembly. INKCLOUD lists its ABS-Like Resin for applications that include careful drilling and hole preparation. For a lid you plan to remove repeatedly, aim for a sliding fit that lets it seat by hand. INKCLOUD ABS-Like Resin · Formlabs guide to fit and tolerances

Test the holes before printing the full lid

Measure the actual metal pins. Print a small test coupon with several hole sizes around the clearance you want. Match the lid’s hole orientation and the thickness around the holes, then wash, dry, and post-cure the coupon using the same process planned for the enclosure.

Try the pins after the coupon is fully cured. Look for a hole the pin can slide into by hand with minimal side play. Once you find a size that works, print a second coupon with both holes at the intended spacing and test it against the pins together. This checks the layout before you commit to the full lid. Formlabs guide to fit and tolerances

Finish a tight hole after curing

If the printed holes give you a repeatable sliding fit, use that size in the lid. If a hole consistently prints slightly undersized, test a smaller printed pilot hole and bring it to the final size after curing.

Use a sharp bit, secure the part, and wear eye protection. For a through-hole, support the exit side with a sacrificial backing block and ease the feed as the bit approaches the far side. Try this on the coupon first. If you see chips missing from the rim, fine cracks, or a rough edge, check the support and cutting setup before drilling the lid. Curbell Plastics drilling guide · Formlabs resin post-processing safety

Check the lid without screws

  • One pin binds on its own. Inspect that hole for a burr or an undersized section.

  • Both pins fit separately, but the lid binds when they’re used together. Check the hole spacing and whether the pins are parallel before widening either hole.

  • The pins slide in, but the lid still rocks. Check the mating faces for raised support marks or distortion.

Once the lid seats flat by hand, record the hole size and any finishing step that worked. Those are the dimensions and steps you’ll want when you print the next revision.

Anterior Próximo
Deixe um comentário 0 comentários

    Leia mais artigos