Silk PLA Filament Settings for Cleaner Support Removal

Use a crescent ornament to test silk PLA support settings. Learn where to place supports, how to tune the contact gap, and what to check after removal.

By XUCHUN

Silk PLA Filament Settings for Cleaner Support Removal

XUCHUN

A silver silk PLA crescent can look smooth from the front, then show a rough patch as soon as you turn it toward a lamp. That patch often sits directly above the supports. For a display piece, start by deciding where a support mark will be least visible. Then tune the gap so the support comes away cleanly without leaving loose strands underneath.

Check where supports touch before changing settings

Choose the side of the crescent you want people to see. Compare the upright orientation with another angle that shifts support contacts toward the back or underside. In the sliced preview, trace the support contacts around the inner curve and both tips. Keep support where an overhang needs it, and choose the orientation that leaves the main display face clear where possible. Prusa guide to model orientation and overhangs

Test the gap on one small overhang

Print a short section of the crescent that includes the supported curve. Use the intended orientation and layer height. For INKCLOUD PLA Silk, the published range is 210–240°C for the nozzle and 55–65°C for the bed. Keep your chosen temperatures steady while you compare support settings. INKCLOUD PLA Silk print settings

When the model and supports use the same filament, start with your slicer profile’s support gap. In PrusaSlicer, Top contact Z distance controls the vertical gap between the support interface and the model above it. Prusa suggests 50–75% of the layer height as a starting range. With 0.20 mm layers, that gives you 0.10–0.15 mm to try on the sample. Let each sample cool before removing the supports. PrusaSlicer support material guide

Adjust based on what the underside looks like

What you see What to try next
The support grips tightly and pulls at the surface. Increase the top contact gap slightly, then check whether it releases with less force.
The support comes off easily, but loose strands hang underneath. Try a smaller gap. If the support already grips firmly, test a denser top interface in a separate print.
The underside looks acceptable, but the mark shows from the front. Revisit the orientation and move the support contacts toward a less visible area.

The support interface is the denser layer at the top of the support structure. It gives the model a more even surface to print over. Change the gap or the interface one at a time so you can see what fixes the problem. Prusa guide to rough surfaces above supports

Print one full crescent with the settings that worked on the sample. Turn it under the light where it will be displayed and check the supported curve from the front and side.

Explore INKCLOUD Silk PLA Filament

Anterior Próximo
Deixe um comentário 0 comentários

    Leia mais artigos