Silk PLA Filament Settings for Ender-3 and Ender-3 V3 SE
XUCHUNIf you’re looking for silk PLA filament settings for an Ender-3, start with the full model name. The original Ender-3 uses a Bowden extruder, which feeds filament through a tube to the printhead. The Ender-3 V3 SE uses a direct-drive extruder mounted on the printhead. You can use the same temperature test on both machines, while tuning retraction for the hardware on each one. Creality Ender series comparison · Creality Ender-3 V3 SE specifications
Start with a small card holder
A low, faceted card holder is a useful test because the flat faces make changes in gloss easy to see, and the slot gives you a place to look for strings. Select your exact printer and nozzle in the slicer. For INKCLOUD PLA Silk on a 0.4 mm nozzle, try this baseline:
| Setting | First test |
|---|---|
| Nozzle | 220°C |
| Build plate | 60°C, if supported by your plate |
| Layer height | 0.20 mm |
| Outer-wall speed | 40 mm/s |
| Retraction | Start with your printer profile. See the model-specific guidance below. |
INKCLOUD lists 210–240°C for the nozzle and 55–65°C for the bed. Keep the first-layer settings from your working printer and plate profile while you compare the visible walls. INKCLOUD PLA Silk print settings
Match the retraction to your extruder
-
Original Ender-3 with the stock Bowden setup. Start with the retraction in your original Ender-3 profile. If the card slot has strings after you settle on a nozzle temperature, change the retraction distance in a small step and reprint. If you’ve converted the printer to direct drive, use a baseline for the installed extruder.
-
Ender-3 V3 SE with the stock direct drive. Start with the V3 SE profile. Creality lists 0.8 mm at 25 mm/s for its CR-PLA on this machine. That gives you a reference for the feed system. Validate retraction on your silk PLA spool and keep the nozzle temperature within that spool’s range. Creality V3 SE material guide · Prusa guide to retraction
Compare the front face before saving the profile
Print the first holder at 40 mm/s outer-wall speed. If you want to see whether a slower wall gives a more even finish, print a second holder at 30 mm/s and keep the temperature and orientation the same. Check the speed preview to see whether both prints actually use different speeds on the front face.
Set the holders under the same lamp and compare the sheen across each facet. Check the card slot for strings and the wall starts for gaps. Save the better profile under the printer model and filament name so you can reuse it on the same setup.