How to Print Silk PLA on Bambu Lab Printers Without Gloss Bands?

Seeing shiny and dull bands on the same silk PLA print? Use Bambu Studio’s Speed preview and a two-sample test to get a more even finish.

By XUCHUN

How to Print Silk PLA on Bambu Lab Printers Without Gloss Bands?

XUCHUN

If a silk PLA print comes off your Bambu Lab printer with a glossy shoulder and a dull body, open the sliced model in Bambu Studio and check the Speed preview. A curved shoulder or an overhang can print more slowly than a straight wall. Silk PLA makes those changes especially visible because its reflective finish responds to changes in speed and temperature. Bambu Lab guide to print speed and gloss differences

Compare the gloss band with the speed preview

Slice your model, open Preview, and select Speed as the color scheme. Move the layer slider to the height where the finish changes. If the speed changes at the same height, test a lower Outer wall speed under Process → Speed. You may need to enable advanced settings to see it. Bambu Lab guide to Bambu Studio print settings

Pay particular attention to the face you’ll see most often. On a vase, that might be the transition from the straight body to the shoulder. Check the preview again after adjusting the outer wall speed. Overhang settings can still slow that part of the wall, so inspect the toolpath around the shoulder before you print. Bambu Lab guide to overhang speed

Run a two-sample test

  1. Pick a representative sample. Use a small model with both a straight side and a curved shoulder, or test a section of the original model that includes the visible transition.

  2. Change one setting. For INKCLOUD PLA Silk, try 50 mm/s and 80 mm/s as two outer wall test speeds. Keep the spool, nozzle temperature, cooling, layer height, and orientation the same. Use the Speed preview to check that the two versions actually produce different wall speeds in the area you’re testing.

  3. Compare the prints under one light. Turn both samples at the same angle and look for an even highlight across the shoulder. Check for clean edges and sound layers before saving the better result as a custom preset.

Adjust temperature after the speed test

If the slower sample looks even but you want more shine, test a small nozzle temperature increase within the range for your spool. INKCLOUD lists 210–240 °C for its PLA Silk. Start from a temperature that already extrudes cleanly and keep the chosen wall speed fixed so you can see what the temperature change does. Check the curved section for stringing or sagging before committing to the full print. INKCLOUD PLA Silk settings and colors

Предыдущий Далее
Оставить комментарий 0 комментариев

    Читать больше статей