How to Clean Water-Washable 3D Printer Resin Prints?

Use two containers to clean water-washable resin prints. Learn how to rinse recessed details, dry parts before UV curing, and collect used wash water.

By XUCHUN

How to Clean Water-Washable 3D Printer Resin Prints?

XUCHUN

A small resin-printed enclosure may look clean after its first wash, yet still hold liquid resin in a screw hole or at the end of a vent groove. With water-washable 3D printer resin, you can use water as directed by the product instructions. A two-bath setup makes it easier to wash away most of the residue first and finish with a cleaner rinse.

Set up two containers before you start

Place two lidded containers in a spill tray. Label them First Wash and Final Rinse. Keep a separate spot for the part to drain and dry. Work in a ventilated area and use the chemical-resistant gloves and eye protection specified in your resin’s safety data sheet. Use the wash method, total cleaning time, and UV curing settings for your exact resin and equipment. ELEGOO resin handling and post-processing guide

Wash the surface, then rinse the recesses

  1. First wash. Gently move the print in the first container to loosen the film of uncured resin. Rotate the enclosure so water reaches the vents and screw recesses. Let the excess drip back into the first container before transferring the part.

  2. Final rinse. Use the cleaner second bath to flush the grooves and recessed holes. Tilt the enclosure so trapped air can escape and water can reach the ends of the grooves. If the final bath starts leaving a film on parts, replace it with fresh water and collect the used rinse.

  3. Drain and dry. Put the part on a dedicated tray with its openings angled down. Let it dry completely, including inside recesses, before UV post-curing. If a groove still holds a glossy film after drying, check it under a light and rinse again with fresh water if you see residue. Dry the part again before curing. Anycubic water-washable resin guide · ELEGOO cleaning and drying guidance

For hollow prints, make sure the design has drainage openings you can access. Rinse the interior through those openings, then give it time to drain and dry fully. On a solid enclosure with recessed vents, focus on the ends of the grooves and the bottoms of the screw holes, where droplets can linger.

Where does the used wash water go?

Collect water from both containers in a compatible, labeled, closed container reserved for resin waste. Keep it out of sinks, toilets, and storm drains, even if the rinse looks clear or has been filtered. Follow your resin’s safety data sheet and ask your local waste authority where to take resin-contaminated water. ELEGOO resin waste disposal guidance

Предыдущий Далее
Оставить комментарий 0 комментариев

    Читать больше статей