How to Batch-Print Stackable Trays with High-Speed PETG Filament?

Batch-print stackable parts trays with high-speed PETG filament. Learn where to increase speed, how to check the stacking fit, and how to measure time per usable tray.

By XUCHUN

How to Batch-Print Stackable Trays with High-Speed PETG Filament?

XUCHUN

A batch of small parts trays looks like an easy job for high-speed PETG filament. The floor has long, straight print paths, and the same model can fill a build plate. The stacking lip is where the fit gets decided. A slight bulge or a curled corner can make two otherwise good-looking trays rock when stacked.

Start with a single tray, then use a small batch to find out how much time your faster settings actually save.

Speed up the floor and preserve the fit

Tray feature What to try
First layer Keep the first-layer settings that give you a flat, secure base on your build plate.
Internal solid fill in the floor Increase this speed in small steps. The long, straight paths are a good place to test whether your printer can sustain more flow.
Exposed floor and outer walls Keep the baseline settings for the first comparison. Check for gaps on the floor and ripples near the corners before changing either.
Stacking lip Keep a proven outer-wall speed here. If the lip has an overhang, check those layers in the slicer preview and use the overhang settings to control them.

Start with a PETG-HF profile that matches your printer and nozzle. INKCLOUD publishes a 230–260°C nozzle range and a 60–80°C bed range for its PETG-HF. It lists speeds up to 500 mm/s on compatible systems. The speed your tray can sustain depends on the hotend, the amount of plastic each line needs, and the geometry. Check the slicer’s speed and volumetric-flow previews to see which paths can actually run faster. INKCLOUD PETG-HF specifications · Prusa guide to maximum volumetric speed

Print one tray and check three things

  1. Check the floor. Look for thin or missing lines where the print runs fastest. If gaps appear after a speed increase, return to the last setting that produced a continuous surface.

  2. Check the corners. After the tray cools, set it on a flat surface. Press lightly on opposite corners and see whether it rocks.

  3. Check the stack. Print a second tray with the same settings. Stack the pair in both orders. Each tray should seat evenly and lift off without catching. If the fit is tight, look for a raised seam or a curled lip before changing the model dimensions.

Measure the batch by usable trays

Run a small batch with the settings that passed the fit check. Record the elapsed print time and count the trays that sit flat, have sound floors, and stack cleanly. Divide the print time by the number that pass.

For example, a 100-minute run with four usable trays takes 25 minutes per usable tray. A 90-minute run with only three usable trays takes 30 minutes per usable tray. Use that figure to decide whether the faster profile earns its place on a full build plate.

Explore INKCLOUD High-Speed PETG Filament

Previous Next
Leave a comment 0 comments

    Read more articles